5/10/2021 0 Comments Ink Manufacturing Process
These decisions are made in accordance with the intended use of the ink.However, there are some general categories of ingredients that are common to most lithographic inks, including pigments, vehicles, additives, and drying agents (driers).
![]() The dry pigment is formed of large clumps of particles called aggregates or agglomerates. These aggregates must be broken down and reduced in size as the pigment is wet with the vehicle. The initial dispersion involves premixing the dry pigment with the vehicle using a mechanism consisting of rotating mixing blades. The second stage of premixing involves adding more oil and resin to form a mill base, Figure 5-11. Inks made from flush pigments may go directly to milling after mixing the primary ingredients. Also, the addition of other ingredients like waxes and driers can be done at this stage. In many cases, this done in a shot mill, which is made up of a chamber, rotating disks, and shot pellets. The ink is forced into the chamber and the rotating disks move the metal pellets through the ink, breaking the pigment down. This shearing breaks up the pigment agglomerates into microscopic particles so that each becomes completely surrounded and wet by the varnish. Milling also classifies the pigment, permitting finely dispersed pigment to flow through the mill and retaining or holding back coarser pigment particles. The ground ink is taken off hte high-speed roll by a doctor blade. A thorough job of grinding may require as many as three passes through the mill, depending on whether the pigment is soft or hard and how easily it is wet by the varnish (Figure 5-13). ![]() Large pigment particles in the ink may cause premature plate wear and scratches in the plate. Since the pigment is the most expensive part of the ink, and uniform dispersion is accomplished by extensive milling, high-quality inks cost more. The filtration system consists of bag filters that have decreasing pore sizes, from 150 microns down to microns. In some cases (particularly when manufacturing inks from dry pigments), an electromagnetic filter is used as a part of the filtration system to eliminate metal fragments. Those particularly, tack, fineness of grind (pigment particle size), and water pickup (emulsification rate). Once the product is assured of meeting requirements, the ink is packaged for shipping.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |